Pages

Tuesday, January 13, 2015

Improv Cross Pillow


Hi, my name is Jamie from Busy Bee Quilts and I have a fun pillow tutorial for you today!  Are you thinking about Valentine’s Day yet?  My December was one bout of sickness followed by another, so I am ready to go overboard on Valentine’s Day decorating to make up for a lousy Christmas holiday!  When I saw the Aqua Red Crush fat quarter bundle, I knew it would look bright and cheerful paired with linen, just the right color combination for January and February.  This month I am happy to bring you a tutorial for making this 18” improv cross pillow.


IMG_8146






Materials:
Instructions:
From the long side (22”) of the fat quarters, cut at least 21 strips of varying widths (I used 2” and 1.5”).  From the linen, cut four 6.5” squares and two 12.5”x18” rectangles.
IMG_8012
Arrange 7 strips from the fat quarters.  You can alternate the red and blue or you can choose not to.  I alternated most of my strips, but not all.  Sew the strips together and press seams open.
IMG_8021
You will make at least three rectangles of strips that look something like the one above (I made 4 rectangles—the more you make, the more choices you have for your final blocks, however you will waste some fabric if you make more than 3).  Measure the width of the rectangle to make sure it’s at least 7”.  If it’s more, that is fine, but less than 7” is not okay.  Add another strip to the rectangle if yours measures less than 7”.  Once your rectangles of strips are sewn, you can use starch or Magic Sizing to help press them as flat as possible.
IMG_8055
Now for the fun part!  Grab your rotary cutter and ruler and cut your fabric into strips.  You don’t need to measure the strips, just remember if you cut a strip smaller than 1.5” in width, not much of the fabric will show up.  I try to vary to widths a bit.  You can cut your lines straight up and down or at an angle.  I like to cut on a slight angle, but the wonkier your angle, the more fabric you will trim off at the end.
IMG_8059
Choose 4-5 strips and sew together.  You can rotate a strip 180 degrees if you need more variation in the placement.  Sew the strips together and press seams open.  You are aiming to have the block measure slightly bigger than 6.5” square.  If one of your lengths falls short, just add another strip.
IMG_8063
Trim your blocks to 6.5” square.
IMG_8064
Arrange the blocks in a 3 x 3 formation.
IMG_8068
Sew the blocks together in horizontal rows.  Press seams open.  Sew the rows together, pinning carefully to line up the seams between blocks.  Press seams open.
IMG_8077
Voila!  You have a beautiful improv cross block that should measure 18.5” square unfinished.  Now you can choose to quilt your pillow top however you’d like.  Once your top is quilted, you can add an envelope closure for the back.  You’ll need two pieces of fabric (I used linen) that measure 12.5” x 18”.
IMG_8096
Press one of the 18” raw edges in 1/2”, then turn another 1/2” and press.  Pin in place and sew the edge down using a straight stitch.  Finish your pillow with binding or serge the layers together for a modern look without binding.


IMG_8125


IMG_8106

I hope you enjoyed the tutorial, and if you make this pillow, please share a photo with Lindsey at lindsey@fortworthfabricstudio.com or on Instagram using the hashtag #sewingwithfwfabricstudio.

-Jamie









3 comments:

sylvie jourdan said...

Hi,Jamie
Welkome and thanks for this beautiful pattern

nickie said...

très lumineux ce coussin !! j'aime beaucoup !!
bizzzzzzzzzzzzzzzz

myfabricconnection said...

Very beautiful. I will try to make this.

Post a Comment